w-005m thru W-10M page: 1 frontier electronics corp. 667 e. cochran street, simi valley, ca 93065 tel: (805) 522-9998 fax: (805) 522-9989 e-mail: frontiersales@frontierusa.com web: http://www.frontierusa.com 1.5a silicon single-phase bridge rectifiers w-005m thru W-10M features z plastic material used carries underwriters laboratory flammability recognition 94v-0 z high case dielectric strength z typical ir less than 1 a z high overload surge capability z ideal for printed circuit board mechanical data z case: epoxy case, dimensions in inches and (millimeters) z terminals: leads solderable per mil-std-202 method 208 z mounting position: any z weight: 1.1 grams maximum ratings and electrical characteristics ratings at 25 c ambient temperature unless otherwise specified single phase, half wave, 60 hz, resistive or inducti ve load. for capacitive load, derate current by 20% ratings symbol w-005m w-01m w-02m w-04m w-06m w-08m W-10M units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 v maximum rms voltage v rms 35 70 140 280 420 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 v maximum average forward rectified current 0.375?(9.5mm) lead length at ta=25 c i o 1.5 a peak forward surge current single sine-wave superimposed on rated load i fsm 50 a storage temperature range t stg - 55 to + 150 operating temperature range t op - 55 to + 125 electrical characteristics (a t t a =25 c unless otherwise noted) characteristics symbol w-005m w-01m w-02m w-04m w-06m w-08m W-10M units maximum instantaneous forward voltage drop per element at 1.0a v f 1.1 v maximum reverse leakage at rated dc ta=25 i r 10 a min 1.0(25.4) pos lead .032(0.81) .028(0.71) .366(9.3) .350(8.9) .220(5.6) .200(5.1) min 1.1(27.9) .220(5.6) .180(4.6) .220(5.6) .180(4.6)
w-005m thru W-10M page: 2 ratings and characteristic curves w-005m thru W-10M fig. 5 - maximum non-repetitive peak forward surge current 60 50 40 30 20 10 0 peak forward surge current, amperes 0 2 4 6 10 20 40 60 100 number of cycles at 60h z t j =150 single sine-wave (jedec method) fig. 4 - typical junction capacitance per bridge element 100 60 40 20 10 6 4 2 1 capacitance, p f 1 2 4 10 2 4 10 20 40 100 reverse voltage, volts t j =25 f=1mhz vsig=50mvp-p fig. 2 - typical reverse characteristics 10 1.0 0.1 .01 instantaneous reverse current, microamperes 0 20 40 60 80 100 120 140 percent of rated peak reverse voltage t a =100 t a =25 fig. 1 - derating curve output rectified current 1.6 1.4 1.2 1.0 .8 .6 .4 .2 0 bridge output full wave rectified current average amperes 20 40 60 80 100 120 140 ambient temperature, 60h z resistive or inductive load pc board .375? 9.5mm copper pads 0.22 in 2 5.5mm 2 capacitive load 50 conduction angle fig. 3 - typical forward characteristics per element 20 10 1.0 0.1 .01 instantaneous forward current, amperes 0.4 0.6 0.8 1.0 1.2 1.4 instantaneous forward voltage, volts t j =25 pulse width=300us 1% duty cycle
|
